SPONSORS
2024 ICRBE EXPO |
Thread spool diameter??
Posted by:
Michael Friddle
(166.82.135.---)
Date: August 17, 2005 09:49AM
What is the typical inside diameter of a thread spool? I need to know so I can mount some rod on my home made thread rapper/dryer. "The early bird gets the worm,.. but the second mouse gets the cheese!" Re: Thread spool diameter??
Posted by:
Billy Vivona
(4.43.114.---)
Date: August 17, 2005 10:15AM
You don't have any spools laying around? It's probably 1/4" Re: Thread spool diameter??
Posted by:
Michael Friddle
(166.82.135.---)
Date: August 17, 2005 10:57AM
Billy Vivona Wrote:
------------------------------------------------------- > You don't have any spools laying around? It's > probably 1/4" > > XL Rods I thought I would get this response or none at all. No I do not. I am building a thread wrapper/dryer to build MY FIRST ROD and have not purchased any other materials yet. Re: Thread spool diameter??
Posted by:
Billy Vivona
(4.43.114.---)
Date: August 17, 2005 11:05AM
Oh. Buy a spool of thread from somewhere - most thread spools have the same ID on them. If i was home, I'd just measure for you, but I'm 95% sure it's 1/4".
Do reaserach in the Archives here, there should be a lot of info on how to build your wrapper. When I built mine I used 1/4" threaded rod and that was perfect. No need to re-invent the wheel here. Re: Thread spool diameter??
Posted by:
Bob Crook
(---.an1.sea18.da.uu.net)
Date: August 17, 2005 11:58AM
1/4" it is. Re: Thread spool diameter??
Posted by:
Doug Moore
(---.dfw.dsl-w.verizon.net)
Date: August 17, 2005 12:03PM
Yep 1/4" Regards......Doug@ TCRds Re: Thread spool diameter??
Posted by:
Michael Friddle
(166.82.135.---)
Date: August 17, 2005 12:05PM
Thanks everyone!! "The early bird gets the worm,.. but the second mouse gets the cheese!" Re: Thread spool diameter??
Posted by:
bill boettcher
(---.nj-01.cvx.algx.net)
Date: August 18, 2005 11:08AM
3/8's also but it is a little snug Sorry, only registered users may post in this forum.
|