SPONSORS
2024 ICRBE EXPO |
pocket butt cap reel seat...
Posted by:
Marc Forrest
(66.241.91.---)
Date: August 05, 2005 12:09AM
Rod Builders,
I need some expert advise. I'm trying to gather the reel seat components I'll need for building a dan craft fast taper 8wt. I'm keen on keeping the handle simple yet strong enough to hold a #8 reel. rather than two slide bands I've elected to use a rear mounted pocket butt cap bonded to the cork with rod bond. please have a look at this graphic [www.mind.net] the only hardware I've come up with so far is the Bellinger... I suspect there are other manufactures tho haven't found them yet. any ideas would be welcome. thanks for a superlative forum. marc forrest Re: pocket butt cap reel seat...
Posted by:
Peter Mulbjerg
(---.aalborg.dk)
Date: August 05, 2005 01:54AM
Hi Marc,
I'm a little unsure what you are asking, but what you describe in the pictures I've done once with an uplocking REC reel seat - just drilled a hole in the butcap and made a small fighting but - no problem. But you need to make sure you can bore out the wood insert to the required ID. Maybe take a look at www.rec.com - they offer the cap/ring reel seat in different sizes and they can make the insert with different ID's. Fitting a reel wont be much of a problem (but try before building though) since most (remember I said most) reels - from small to quite large - have the same size reel foot. Peter EDIT: just realised that you dont want a wood insert - forget about ID then - the rest can easily be done. You might just have to do a mortise in the cork if you dont choose to reduce the OD of the cork insert compared to the ring ID, make a flat side or an oval spacer - you need room for the reel foot. Post pictures once finished please! Edited 2 time(s). Last edit at 08/05/2005 05:59AM by Peter Mulbjerg. Re: pocket butt cap reel seat...
Posted by:
Dan L Craft
(---.eugn.qwest.net)
Date: August 05, 2005 03:34AM
Marc,
The UL5 seats from Pac Bay sound like what you need. I have a couple of the end caps. Give me a call. Dan Craft Re: pocket butt cap reel seat...
Posted by:
Marc Forrest
(66.241.91.---)
Date: August 05, 2005 07:44PM
Thanks Peter and Dan,
sounds good, i'll investigate some more end caps and keep you posted on my progress cheers! marc Sorry, only registered users may post in this forum.
|