SPONSORS
2024 ICRBE EXPO |
Dust Filter
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: August 04, 2005 07:53PM
If you are looking for a very inexpensive dust filter for your mini-lathe (or other tools), check this out [www.rodbuilding.org]
Tom Kirkman originally posted the idea. Doesn't do a lot with shavings but is fantastic with dust!! Mike Re: Dust Filter
Posted by:
Michael Sledden
(208.21.98.---)
Date: August 05, 2005 07:33AM
I use the same thing and it works great for me. Also use the same thing for my airbrushing of lures to collect the overspray. Found out with using it for my lathe, take the shop vac to the filter and clean up the dust off of it and your good to go again. Sorry, only registered users may post in this forum.
|