SPONSORS
2024 ICRBE EXPO |
Permagloss over LS Supreme?
Posted by:
James Mello
(---.haydrian.com)
Date: July 14, 2005 02:55PM
I've got a couple of small sections on a rod where I did some touch up after getting the epoxy on. I ended up clipping a couple of stiff fuzzies and also lightly sanding a rough spot. The epoxy for the most part is the right thickness, so I don't really want to add another coat. Can I get away with putting a thin coat of Permagloss on this to just touch it up, or will the solvent in Permagloss damage the existing epoxy? I know that it's fine to go the other way around, but I want to see if anyone has done this!
-- Cheers -- James Re: Permagloss over LS Supreme?
Posted by:
Stan Grace
(---.hln-mt.client.bresnan.net)
Date: July 14, 2005 07:34PM
I have never had a problem using Permagloss over LS if the LS is cured for 24 hrs. It may not need that much curing but I haven't tried it with less. Stan Grace Helena, MT "Our best is none too good" Re: Permagloss over LS Supreme?
Posted by:
Mick McComesky
(---.245.86.29.Dial1.StLouis1.Level3.net)
Date: July 14, 2005 11:44PM
I've used it on the handful of rods that I've used LS on, and routinely use it on Flex Coat. I've never had any problems at all. Like Stan, I've never tried using it less than about 24 hours, but I've never had a need to attempt it. Just the way the clock works. Sorry, only registered users may post in this forum.
|