SPONSORS
2024 ICRBE EXPO |
Winston LT blank question
Posted by:
Darrin Dembowski
(---.cpe.net.cable.roger)
Date: July 09, 2005 03:26PM
Anyone build on a Winston LT blank??? Just recieved mine and the butt section is 1 inch shorter than the other 4 pieces which all measure out the same. Is this normal???
thanks Re: Winston LT blank question
Posted by:
Spencer Phipps
(---.lsil.com)
Date: July 09, 2005 04:55PM
When you put the reelseat, buttcap, or fighting butt on all will even out or it could be a little longer than the other sections. Have used other blanks that were that way. Re: Winston LT blank question
Posted by:
Darrin Dembowski
(---.cpe.net.cable.roger)
Date: July 09, 2005 05:20PM
I put it in the reelseat (just slid it in) and its still shorter than the other pieces. Perhaps its supposed to be like that but I own another factory LT and the butt is actually 1/4 inch longer than the other 4 pieces. Re: Winston LT blank question
Posted by:
Bill Moschler
(---.westk01.tn.comcast.net)
Date: July 09, 2005 06:53PM
I have built 2 LT blanks. to the best of my memory all the sections were the same length. I think you need to call winston and see what they say. I think you have a short section. Re: Winston LT blank question
Posted by:
Darrin Dembowski
(---.cpe.net.cable.roger)
Date: July 09, 2005 09:05PM
Thanks. Sorry, only registered users may post in this forum.
|