SPONSORS
2024 ICRBE EXPO |
Section length of DC 9' 5wt
Posted by:
Aaron Mauck
(---.hsd1.co.comcast.net)
Date: July 02, 2005 01:54PM
I recently ordered a Dan Craft 9' 5wt Sig V and was trying to locate the section length for the three pieces so I can start on my case. Does anyone have that spec, built that particular rod or know the case size off the top of there head? Is there a post that keeps information like that? I appreciate any help.
Re: Section length of DC 9' 5wt
Posted by:
Dennis Papike
(---.broadband.oakhurst.)
Date: July 02, 2005 04:28PM
They are 37 1/2" give or take. I'd probably build it at 38" to allow a little extra for a rod sock. Re: Section length of DC 9' 5wt
Posted by:
Jeff Shafer
(---.phil.east.verizon.net)
Date: July 02, 2005 07:17PM
You actually may want an added inch on either end if you ship this case either in air cargo or land freight, and want to place something spongy on both ends to absorb the shock of being thrown around. Blunt trauma to the end of the case can cause breakage if the rod slides even a short distance then stops abruptly.
Jeff Shafer Sorry, only registered users may post in this forum.
|