SPONSORS
2024 ICRBE EXPO |
Finding the spine of a multi piece rod?
Posted by:
Tyler Bell
(---.sympatico.ca)
Date: June 26, 2005 12:18AM
I am building my first multi piece rod and I have run in to a problem I can't seem to figure out how to spine it ? can any one help me out with this problem? step by step procedure would be appreciated but at this point I will take any help out there.
Thank you Tyler Re: Finding the spine of a multi piece rod?
Posted by:
Michael Sledden
(---.dsl.emhril.ameritech.net)
Date: June 26, 2005 02:35AM
The way I was told, you spine each section. The starting with the tip and next section, put them together on the marks for the spine, and then spine them together. You may hav to adjust the 2 pieces to get them spined correctly. from there ad the next piece and keep working till you have the rod spined. Re: Finding the spine of a multi piece rod?
Posted by:
Anonymous User
(Moderator)
Date: June 26, 2005 05:28AM
Your answer is on the FAQs page. MIke's method will also work well.
........................ Sorry, only registered users may post in this forum.
|