SPONSORS
2024 ICRBE EXPO |
centerboring customgrip
Posted by:
Mark Gallihugh
(---.proxy.aol.com)
Date: June 21, 2005 03:26PM
I`VE BEEN EYEBALLING IT FOR TO LONG! I HAVE SOME CUSTOMGRIP SOLID STOCK ALL GLUED TOGETHER BUT I DON`T WANT TO TAKE THE CHANCE OF BORING IT OFFCENTER .I`M SURE SOMEONE KNOWS A TRICK OR HAS BUILT A JIG FOR THIS JOB.THE PIECES ARE ABOUT 2X5 IREALLY DON`T WANT TO CUT THEM SMALLER.ANY HELP WOULD BE GREATLY APPRECIATED
Mark Re: centerboring customgrip
Posted by:
Billy Vivona
(4.43.114.---)
Date: June 21, 2005 03:45PM
Might be photos posted by Talisman, or Tal1sman on the old photo page. Do a search here for boring customgrip, I think I asked this at some point and got a few answers. I've tried 1/2"ID tubing sharpened & eyeball the EVA feeding in, did not like the results I got, as the CG heated up and clogged the hole (I used Aluminum & copper tubing) & the hole was bored slightly off center. To be quite honest, not one person noticed the grips were not 100% perfectly symetrical, but for the amount of work I put in, I notice and hate teh grip. Talisman uses a simple jig & gets it right every time. Re: centerboring customgrip
Posted by:
Mark Gallihugh
(---.proxy.aol.com)
Date: June 21, 2005 03:58PM
Thanks Billy I`ll look it up.
Mark Re: centerboring customgrip
Posted by:
Billy Vivona
(---.ny325.east.verizon.net)
Date: June 21, 2005 07:21PM
I only have access to this site from work, so I couldn't search for you.
HEre is the link to the pics Mike posted on the jig e uses. I know there are posts in teh archives here, hopefully you can find them: [www.fishingphotos.net] Sorry, only registered users may post in this forum.
|