SPONSORS
2024 ICRBE EXPO |
2pc Flyrod spine
Posted by:
Steve Parks
(---.hurtl301.al.comcast.net)
Date: April 09, 2002 06:09PM
I've got an olive green 2pc Rainshadow blank and spined both sections. When I put the sections together on the marks, the spine is now a few degrees to one side. Should I turn the butt section until the top section marks are in their orignal spined position? Thanks, Steve Re: 2pc Flyrod spine
Posted by:
Ricky Wilson
(---.proxy.aol.com)
Date: April 09, 2002 07:06PM
I have read about this on the FAQS page on this site. Something about the overlap of the ferrule throwing it off just a bit. So you remark the sections to reflect where the spine effect now is located. Keep the top and bottom section aligned with each other. Sorry, only registered users may post in this forum.
|