SPONSORS
2024 ICRBE EXPO |
fuji nps reel seat
Posted by:
Bryan Burbank
(66.0.239.---)
Date: June 01, 2005 03:07PM
i purchased a couple of the fuji nps reel seats and would like to know which way to mount...
should i locate the nut and threaded end towards the butt grip or towards the fore grip? thanks bryan... Re: fuji nps reel seat
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: June 01, 2005 03:14PM
Whichever way is comfortable for you. I prefer the thread to the rear and just "ramp" epoxy and wrap right up to the seat with no foregrip
Mike Re: fuji nps reel seat
Posted by:
Anonymous User
(Moderator)
Date: June 01, 2005 04:05PM
I mount the threads to the front and find the rear sloping section very comfortable in my hand. It's a matter of personal preference.
............ Re: fuji nps reel seat
Posted by:
bill boettcher
(---.250.42.114.Dial1.Weehawken1.Level3.net)
Date: June 01, 2005 04:16PM
Put the seat on with some tape and play with it too see which way you like it Re: fuji nps reel seat
Posted by:
Bryan Burbank
(66.0.239.---)
Date: June 01, 2005 05:56PM
thanks for the information...i always like the nut & threads on top down locking...that's just me...
again thanks...bryan... Re: fuji nps reel seat
Posted by:
Mike Moore
(---.kla-tencor.com)
Date: June 01, 2005 06:55PM
Bryan, if you want, you can try what I did on the last nps seat I mounted with the threads toward the rod tip. I pulled out the reel I was planning on using, mounted it on the seat and tightened it down. then I marked the exposed threads, and then cut off that exposed section. Once the seat was mounted, I put on a very short cork foregrip(really just a tapered section about 1/2in. long.) that was the same diameter as the threads. The threaded reel hood can unscrew over this thing, and once you get the reel on, no threads show.....it's a pretty clean setup. Sorry, only registered users may post in this forum.
|