SPONSORS
2024 ICRBE EXPO |
Turning cork handles 101
Posted by:
Tom Markham
(---.hsd1.il.comcast.net)
Date: May 01, 2005 02:47PM
OK, these are basic questions, and I think I already know the answers but I need to ask just to be sure there isn't anything I'm missing.
Question 1: When I turn my cork handles, it seems inevitable that they will be some what out of round with the blank itself (i.e. the cork is higher on one side than it is on the other). What tips do you guys have keep your cork handles perfectly round with the blank when shaping them? Question 2: I have seen diagrams in RodMaker magazine where a cork handle is show with various outside diameters and tapers. I have a pair of calipers for measuring, but what steps do you take to shape the handle? I took a wood shop class in high school where we used wood on a lathe. Basically, we would measure the piece of stock and mark the changes in O.D., then we would use a small cutting tool to bring that section down to its desired O.D. Then we would use large cutting tools to shape the wood between those points until the proper transition was achieved. Do you take the same steps with cork? Obviuously you don't use cutting tools with cork, but do you first bring a section of the cork down to its desired O.D, then remove the space between until the transition you want is made? Just looking for some all around good tips when it comes to shaping cork. Thanks! Edited 1 time(s). Last edit at 05/01/2005 02:48PM by Tom Markham. Re: Turning cork handles 101
Posted by:
Ellis Mendiola
(---.dsl.hstntx.swbell.net)
Date: May 01, 2005 03:36PM
You can use your cutting tool and very lightly round the cork handle before you start sanding. Sometimes when you bore out the hole, if you are not careful, you can sand the hole out of center then when you slip the handle on the blank it will make the grip look higher on one side. Re: Turning cork handles 101
Posted by:
Anonymous User
(Moderator)
Date: May 01, 2005 04:40PM
How to do all this, was covered in-depth in two articles in RodMaker a while back. Those issues are stil available. I also covered it in the book I did for Amato publications - Rod Building Guide.
You have to get your grip concentric by cutting with a wood scraper to start. Once you get it concentric with the blank, you can begin shaping by sanding. Overall, you have to work cork differently that you do wood. Most of the shaping is done by sanding rather then cutting with a wood cutting tool. It takes some practice to be able to get the various shapes you desire, but it's not terribly difficult to learn. You have just have to gain some experience by a doing several. ................. Edited 1 time(s). Last edit at 05/01/2005 07:13PM by Tom Kirkman. Re: Turning cork handles 101
Posted by:
Jay Lancaster
(---.clis.com)
Date: May 01, 2005 06:58PM
Yep it's in Tom's book. Very informative.
Jay Re: Turning cork handles 101
Posted by:
Gene Rehberg
(---.an7.chi30.da.uu.net)
Date: May 01, 2005 09:54PM
Tom, take a piece of sandpaper and wrap it around the front end of a piece of 3/4 inch wood about 2 inches wide and use that on a tool rest as you would a lathe chisel, until you get the piece round, then start shaping from there. You need a steady rest so the cork does not get out of round. Best regards, Gene Sorry, only registered users may post in this forum.
|