SPONSORS
2024 ICRBE EXPO |
removing rod tip
Posted by:
DON DANFORTH
(---.proxy.aol.com)
Date: April 30, 2005 08:34AM
Iam having trouble removing ROLLER TIP FROM A PENN ROD THAT IS 15 YEARS OLD
I HAVE HEATED IT 3 TIME STILL NOTHING ANY SUGGESTION THANK YOU DON DANFORTH Re: removing rod tip
Posted by:
Fred Yarmolowicz
(---.brick101.nj.comcast.net)
Date: April 30, 2005 09:10AM
Don,I ran into this and I too could not get it loose with heat.I was afraid of damaging the blank.Being that it was a heavy trolling rod I decieded to split the tip tube with a dremel and stick a screwdriver between the halves and twist.Care must be taken to keep the tube cool while cutting (cut through slowely and cool with water ).My theory with it being a trollng rod was that if I did overheat the tip and damage the blank it could afford to be a little shorter without a noticeable effect on performance.However, try boiling water for heat ,that usually does it for reel seats but at that end of the rod you can aplly a litte more muscle to break things loose. Freddwhy (Rapt-Ryte) Sorry, only registered users may post in this forum.
|