SPONSORS
2024 ICRBE EXPO |
Muti-rod dryer
Posted by:
Phil Richmond
(---.amer.csc.com)
Date: April 29, 2005 08:34PM
What are the options? I see the double Sully's is $99. Pac-Bay came out with a four rod dryer, but I can't find any prices on it or where it is for resale.
Any other's out there or any recommendations? Phil Re: Muti-rod dryer
Posted by:
Jason Weber
(---.houston.res.rr.com)
Date: April 29, 2005 08:37PM
Flexcoat makes a four rod dryer. I have one and it works great...kinda pricey though. Re: Muti-rod dryer
Posted by:
Phil Richmond
(---.amer.csc.com)
Date: April 29, 2005 08:56PM
Yeah, too pricey for me, crossed it off the list real quick. Not looking to spend over $200. Re: Muti-rod dryer
Posted by:
John Raymond
(---.dsl.tc3net.com)
Date: April 29, 2005 09:10PM
Phil, you can make a drum type dryer, using a barbeque motor or any type motor for that matter. i used a telecoping tent pole, ground a bolt square to fit in it, bolt through the rubber crutch end. cut some circles, glued some 1/2 material on the circles tapped them for thumb screws so i can move them around on the pole. still going strong after 5 years. real cheap to make too. oh. square end of bolt goes in motor. John Re: Muti-rod dryer
Posted by:
Anonymous User
(---.proxy.aol.com)
Date: April 29, 2005 09:20PM
Go to the place near that sell Gas Grills and BBQ pits. There is a rotisserie attachment for nearly all of them that is a motor, shaft and normally four to six prongs on each end. Wack the shaft in the middle and install PVC extension and holders for as many as you want.
Gon Fishn Re: Muti-rod dryer
Posted by:
William Bartlett
(---.proxy.aol.com)
Date: April 29, 2005 09:47PM
Tom Kirkman has pictures of his dryer in the picture section under equipment check it out!! Bolts to the ceiling up out of the way, pretty nice set-up. Bill in WV Re: Muti-rod dryer
Posted by:
Neal Cissel
(---.phnx.qwest.net)
Date: April 30, 2005 08:57PM
We at Neal's Fishing Products sell the Qaud dryer of Pac Bay's, we don't have any instock right now but if you are wanting to know the price feel free to email us at neal@nealsfishingtackle.com
Sorry, only registered users may post in this forum.
|