SPONSORS
2025 ICRBE |
Matrix Blanks
Posted by:
David Forrest
(---.cable.ubr02.uddi.blueyonder.co.uk)
Date: April 26, 2005 05:04PM
I have decided to build my first fly rod , I was thinking of using a matrix 8'6'' #5 two piece blank , are these any good .
David . Re: Matrix Blanks
Posted by:
Phil Richmond
(---.centcom.mil)
Date: April 26, 2005 06:19PM
I have two of the spinning blanks and like them. Haven't heard anything bad about them. Re: Matrix Blanks
Posted by:
Gerry Rhoades
(---.unifield.com)
Date: April 26, 2005 06:38PM
I'm currently building two matrix fly rods, already built an 8'4 weight. I suspect that the blank your're considering will actually be a 6 weight if you check it with the CC method. Check the CCS data and you'll see that what few have been tested all tested out as higher line weights. These are nice blanks, nicely finished and very quick. Re: Matrix Blanks
Posted by:
David Forrest
(---.cable.ubr02.uddi.blueyonder.co.uk)
Date: April 27, 2005 03:40PM
Thanks Gerry , that's just the info I need .
Davy . Sorry, only registered users may post in this forum.
|