SPONSORS
2024 ICRBE EXPO |
P_Touch Labels
Posted by:
Ed Fontes
(---.hsd1.ma.comcast.net)
Date: April 10, 2005 07:47AM
Has anyone had any experience using laminated labels, like P-Touch, for signatures on rod blanks? I tried using them but they delaminated when I put on the epoxy. These would be great to use because you can make them as you need. Re: P_Touch Labels
Posted by:
KEITH BURNETTE
(---.roa.east.verizon.net)
Date: April 10, 2005 07:52AM
ED,
I USE P-TOUCH LABELS ALL THE TIME. IN THE BEGINNING I HAD THE SAME PROBLEM. I PUT A COAT OF GUDEBROD 811 OVER THE LABEL TO SEAL IT. WORKS EVERY TIME. KEITH BEDROCK RODS Re: P_Touch Labels
Posted by:
Don Lukehart
(---.pitt.east.verizon.net)
Date: April 10, 2005 03:18PM
I have been using Sally Hansen's hard as nails. Figured if it is good for Clouser Minnow barbell eyes,why not? Works fine. Sorry, only registered users may post in this forum.
|