SPONSORS
2024 ICRBE EXPO |
How long on the dryer?
Posted by:
Fred Duncan
(---.dsl.mindspring.com)
Date: March 29, 2005 06:46PM
Using U 40 high build, how long should I let the dryer turn? Re: How long on the dryer?
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: March 29, 2005 06:56PM
I'd give it 3 hours just to be sure. Might be able to get by with 2 but 3 would be much safer... and it depends on your room temperature, too. Putter Williston, ND Re: How long on the dryer?
Posted by:
Bob Mahoney
(70.84.56.---)
Date: March 29, 2005 07:38PM
I always let mine run for at least hours. Just in case! Better a little too long than a little too little. Re: How long on the dryer?
Posted by:
Mike McGivney
(---.jdover01.nj.comcast.net)
Date: March 29, 2005 08:25PM
I use Flex Coat Hi-Build and normally let it turn overnight. Re: How long on the dryer?
Posted by:
Tom Doyle
(---.ipt.aol.com)
Date: March 29, 2005 09:30PM
Why be unsure? Leave the unused epoxy out on its flat surface, test to see that it has firmed up, test it with a toothpick (can still be tacky) before offing the dryer. But agree with comments above re Flex Coat: 2 hrs usually ok, 3 safer. Re: How long on the dryer?
Posted by:
Ellis Mendiola
(---.dsl.hstntx.swbell.net)
Date: March 29, 2005 09:55PM
I use Tom Doyle's method. I also use toothpicks and normally 2 to 3 hours is enough. Re: How long on the dryer?
Posted by:
Fred Yarmolowicz
(---.brick101.nj.comcast.net)
Date: March 30, 2005 06:31AM
I usually apply finish last thing at night and let it run all night.That way there is no temptation to screw it up. Freddwhy (Rapt-Ryte) Sorry, only registered users may post in this forum.
|