SPONSORS
2024 ICRBE EXPO |
cork tape issue
Posted by:
josh kantrowitz
(63.117.201.---)
Date: March 29, 2005 03:29PM
when using cork tape i finish the ends with thread and then epoxy, and before i wrap them i tape them down. what is the best way to secure the butt end of the cork tape which will then be covered by a rubber butt cap? should i wrap that end as well or can i leave in taped and just cover the tape w/rod bond?
thank you josh Re: cork tape issue
Posted by:
russ blanchard
(---.ri.ri.cox.net)
Date: March 29, 2005 03:45PM
No need to make a project out of this..............Just wrap the end with electrical tape and slide the butt cap on.
At least thats what most guys I know do... Re: cork tape issue
Posted by:
Edward Woltering
(---.suffolk.lib.ny.us)
Date: March 29, 2005 07:03PM
.
i use double face tape from a golf shop $6.00 per roll.i go left with the double face tape and right cork tape. it hold the cork tape better to the blank. the glue on the tape is not that sticky. you can use crazy glue the end's down with it. then thread and epoxy it.!!!!!!! Eddie Re: cork tape issue
Posted by:
Fred Yarmolowicz
(---.brick101.nj.comcast.net)
Date: March 29, 2005 08:58PM
I have always been fortionate enough to have a cap that fit tightly and let that hold the tape on.Havent had a failure yet. Freddwhy (Rapt-Ryte) Re: cork tape issue
Posted by:
James(Doc) Labanowski
(---.proxy.aol.com)
Date: March 29, 2005 11:29PM
Tape is great and shring tube works good too. I usually put a turks head at the forgrip end and one just above the buttcapp just to make it nautical. Re: cork tape issue
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: March 30, 2005 01:06AM
Doc, are you always building things naughty? Didn't know you had the Turks head down, ya ol' swabbie!! Sorry, only registered users may post in this forum.
|