SPONSORS
2024 ICRBE EXPO |
EVA grip installation
Posted by:
Bill Hayes
(---.proxy.aol.com)
Date: March 23, 2005 02:43PM
Hey guys,
I'm building a casting rod and I'm using an exposeed blank reel seat. The instructions with the reel seat say to install the reel seat first ( for obvious reasons), and to install the rear grip from the butt of the rod. My issue, I'm using an eva grip, and the ID is smaller than the diameter of the rod butt ... What is the best way for me to install the rear grip and insure that I'll get a good layer of epoxy or glue spread out under it? Thanks in advance, Bill Sorry, only registered users may post in this forum.
|