SPONSORS
2024 ICRBE EXPO |
making a push stick
Posted by:
sante morrone
(---.rc-mres.charterpipeline.net)
Date: March 16, 2005 11:31PM
I was just wondering what size holes should i bore and how many Sante Morrone the fisherman Re: making a push stick
Posted by:
Ken Preston
(---.longhl01.md.comcast.net)
Date: March 17, 2005 12:05AM
Sante -
This sort of depends on the diameter(s) of the rods and the grips. The one I have has 4 holes, only three of which I use: 1/2" ; 3/4" 5/8" and one full inch. I've never used the 1" diameter and the 5/8" gets very little use. Try to make the one that you'll use the most in the center of the board. The one I made I used a 3" wide x 12" piece of 'hard maple' that I got from the Home Depot back in the trim area. I'd also recommend that you smooth out the top edges with a round-over bit and then sand it well - and put a couple of coats of spar varnish on it. Just makes for a nicer tool. Re: making a push stick
Posted by:
sante morrone
(---.rc-mres.charterpipeline.net)
Date: March 17, 2005 10:22AM
thanks ken the idea sparked from watching your dvd
Sante Morrone the fisherman Sorry, only registered users may post in this forum.
|