SPONSORS
2024 ICRBE EXPO |
Tip Size help needed please
Posted by:
Daniel Rees
(---.l6.c4.dsl.pol.co.uk)
Date: January 30, 2005 12:56PM
Just ordered myself a Dan Craft FT 9' #8. In the Dan Craft catalogue it gives a tip size of 5.0. Is this the I.D. of the tip ring i will require or will a 5.0 tube be too tight a fit and therefore will need a 5.5? Re: Tip Size help needed please
Posted by:
Spencer Phipps
(---.lsil.com)
Date: January 30, 2005 02:37PM
His tip sizes have been accurate for me so far. He can size the tip on the blank he sends you and let you know what it is, probably no problem. Spencer Re: Tip Size help needed please
Posted by:
Richard E. Case
(---.sd.sd.cox.net)
Date: January 30, 2005 09:46PM
Usually, the tip size advertised for the blank is the tip size you need to slip over the tip of the rod i.e., if the tip size says 5, then a 5 tiptop should slide right over the tip. If you want to be sure before you order the tiptop, you might want to get a tip sizer. Most of the sponsors carry them and there only a couple of dollars. Well worth the money.
Rick Case RodsByRick Sorry, only registered users may post in this forum.
|