SPONSORS
2024 ICRBE EXPO |
male end wrap
Posted by:
Bruce Tomaselli
(---.dioceseaj.org)
Date: January 25, 2005 02:04PM
Thanks for all the help. Things are starting to become more clear.
Question: I can understand why you wrap the female end because it's hollow. Where do you place the wraps on the male end? Do you mark the male blank where it starts after inserting it into the female blank? Re: male end wrap
Posted by:
bill boettcher
(---.an3.nyc41.da.uu.net)
Date: January 25, 2005 02:25PM
no wrap needed on the male end. just fill the male end with a little epoxy if there is nothing there Re: male end wrap
Posted by:
LARRY PIRRONE
(---.los-angeles-69-70rs.ca.dial-access.att.net)
Date: January 25, 2005 03:36PM
you would only wrap a male end if it was a spigot ferrul. tip over butt there is no need although some folks have put a small wrap there for an alignment dot. Re: male end wrap
Posted by:
Ralph D. Jones
(---.att.net)
Date: January 26, 2005 10:02PM
If you do wrap the male end make sure to leave a bit, 1/4in. or so for the pieces to wear, just as a spiggot ferrule has. Ralph If at first you don't succeed, go fishing, then try, try again. Re: male end wrap
Posted by:
Ralph D. Jones
(---.att.net)
Date: January 26, 2005 10:03PM
If you do wrap the male end make sure to leave a bit, 1/4in. or so for the pieces to wear, just as a spiggot ferrule has. Ralph If at first you don't succeed, go fishing, then try, try again. Sorry, only registered users may post in this forum.
|