SPONSORS
2024 ICRBE EXPO |
Filling Ferrules??
Posted by:
Tom Costa
(---.173.66.34.ptr.us.xo.net)
Date: January 18, 2005 10:39AM
Hi All,
I am starting to build a 4 piece 9' 9wt T&T Horizon blank and was wondering how I am supose to fill in the top of each section of blank? Can I used rod bond, epoxy, something else? Is this even nessesary? Does it need to be sealed? Thanks, Tom Re: Filling Ferrules??
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: January 18, 2005 11:03AM
It is important; the male end of the ferrule can 'crush' and Rod Bond would be my choice.
Putter Re: Filling Ferrules??
Posted by:
Tom Costa
(---.173.66.34.ptr.us.xo.net)
Date: January 18, 2005 11:32AM
Thanks Putter! Re: Filling Ferrules??
Posted by:
Jeff Shafer
(---.airproducts.com)
Date: January 18, 2005 12:07PM
As with Putter, I also use Rod Bond, and use a flat stick to "stuff" around one quarter to one third of an inch into the male ferrule.
Jeff Shafer Re: Filling Ferrules??
Posted by:
Joe Hart
(---.ca-sanfranc0.sa.earthlink.net)
Date: January 18, 2005 01:43PM
Can the Rod Bond be colored to match the blank? Thanks, J.M. Hart Re: Filling Ferrules??
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: January 18, 2005 04:50PM
Joe-
I see Dan Grulke just did this with some black; his post is above this one several spots. Putter Re: Filling Ferrules??
Posted by:
Joe Hart
(---.ca-sanfranc0.sa.earthlink.net)
Date: January 18, 2005 10:39PM
Randy, Thanks for the info, much appreciated, Joe Sorry, only registered users may post in this forum.
|