SPONSORS
2024 ICRBE EXPO |
rod tube
Posted by:
Steve Mason
(---.cg.shawcable.net)
Date: November 30, 2004 06:12PM
I am planning of making leather covered rod tubes, I can not find a source for the tubes, I do not need a finished rod tube, just the tube no cap or end. In brass or aluminum etc. If anyone can help with this I would appreciate it. Thanks much. S.M. Re: rod tube
Posted by:
Spencer Phipps
(---.client.comcast.net)
Date: November 30, 2004 06:58PM
Try Angler's Workshop, they custom make rod tubes to any length you want, so I'm sure they will sell you just the tube also. Re: rod tube
Posted by:
Barret Chrisman
(---.raytheon.com)
Date: November 30, 2004 07:01PM
Steve, If all you need is the tube, I am sure there are some metal supply houses out there that can custom cut aluminum tubing for cheap. Another option would be a machinist. REC (to the left) might also help. Barret Re: rod tube
Posted by:
Austin Sutch
(---.client.mchsi.com)
Date: November 30, 2004 07:18PM
Go to an electrical supply house, and ask for rigid aluminum conduit. Available from 1/2 to 5 inch Diameter Re: rod tube
Posted by:
John Dow
(---.snet.net)
Date: November 30, 2004 08:09PM
REC has specials from time to time on oddball tubes . Try and give Dan an e-mail , I'm sure he will help you if you don't have any luck locally. JD Re: rod tube
Posted by:
Bryan Yee
(---.sd131.k12.id.us)
Date: December 01, 2004 12:35PM
I would use pvc tubbing for sprinkler pipe. It's more crush resistant than that thin wall aluminum stuff that you get with your sages. And it is dirt cheap. I think schedule 40 is the right thickness. Sorry, only registered users may post in this forum.
|