SPONSORS
2024 ICRBE EXPO |
Machine Shop
Posted by:
Mike McGivney
(---.jdover01.nj.comcast.net)
Date: November 28, 2004 08:43PM
Anyone know a good machine shop in Ocean County NJ? Probably a long shot, but figured I'd ask.I need a sleeve made with set screws to attach my sewing machine motor directly to a chuck without pulleys. Thanks Re: Machine Shop
Posted by:
Jeff Fultz
(---.client.comcast.net)
Date: November 28, 2004 09:10PM
Mike, If you let me know the dimensions you need, I can make a coupling sleeve for you out of stainless steel, aluminum, brass,etc... This is just one of the many reasons I got a metal working lathe for my rod shop. Re: Machine Shop
Posted by:
Mike McGivney
(---.jdover01.nj.comcast.net)
Date: November 28, 2004 10:43PM
Thanks Jeff. I'll get the measurements together and send you an e-mail. Thanks again Re: Machine Shop
Posted by:
Robert Tignor
(---.va.client2.attbi.com)
Date: November 28, 2004 11:06PM
This is great one rodbuilder helping out another. Thats what this site is all about anyway.Where else can you go to get your questions answered and make friends at the same time .What a deal. Re: Machine Shop
Posted by:
Dennis J. Danku
(---.proxy.aol.com)
Date: December 01, 2004 12:16PM
Hello Mike, I have one I could send you that I made a few years ago for a Rod Smith to fit a PAC- BAY chuck. I think its 1/4 X 1/4 ID aluminum W/ set screws. Just E-Mail me. No charge, I have extras. Dennis Re: Machine Shop
Posted by:
Dennis J. Danku
(---.proxy.aol.com)
Date: December 01, 2004 12:37PM
Mike, The exact measurements are 0.313 X 0.243 ID X 2" long X 1/2" Dia. If this is what you need, e-mail me. I'm in NJ also. Dennis Sorry, only registered users may post in this forum.
|