SPONSORS
2024 ICRBE EXPO |
Results 31 - 34 of 34
7 years ago
Arthur Amaral
Thank you James for the replay and information. The RCKJB700-250 is the most appealing from the 3 recommendations that you provided. If it would make any difference, I'd shave off 6'' from the butt end of it. I'll try to find someone local with that blank to check it out. Still wishing for that low weight blank but as I mentioned, it may be dreaming.
Forum: rodboard 7 years ago
Arthur Amaral
Roger, I do think that I'm asking too much and am afraid that may be the only way to go. Craig, I'll look at those blanks shortly. Ron, each boat is different, some use 50 mono on the outrigger rods and some use over 100lb braid. As far as drag goes, I haven't actually measured it. Penn 113h and diawa 450h are the most popular star drag reels and myself and other mates go by feel, after setting t
Forum: rodboard 7 years ago
Arthur Amaral
Thank you for the reply. The BP series that you mentioned is the RX4 line up correct? The only rod in that line up was model SWS70MH. It's weight isn't too bad at 4.5 ounces. Would you suggest cutting 6 inches from the top for more backbone? The R6/E-glass models remind me of the Grafighter rods, graphite down below, glass above. Looking at the weight of the models and what I need them to do (be
Forum: rodboard 7 years ago
Arthur Amaral
First timer here, so please forgive the long post. I'm not sure if I am asking too much of this or just haven't been guided properly. I fish on charter fishing boats for striped bass and all of the boats use fiberglass rods while trolling. The reels themselves are about 30 ounces plus the weight of the rods with aluminum butts and very frequently, it can be noticed that clients can be fatigue by
Forum: rodboard |