SPONSORS
2024 ICRBE EXPO |
Results 31 - 41 of 41
12 years ago
scott stevens
31. Re: decal
seems like too much hassle to redo it. The rod is for me ( second build) so its not that big of a deal. Now I know
Forum: rodboard 12 years ago
scott stevens
33. decal
blank supplier said I could put the rod info decal they supply directly on the rod blank and finish over it which I did and it worked fine. However I can see the edges of the decal, which I dont like. Any way to make it "disappear" next time?
Forum: rodboard 12 years ago
scott stevens
34. finish in eyes
built my first rod today and thought I did o.k. on the finish. wrong. After having it on the dryer about 2 hrs I discovered finish in two of the eyes What can I do? They are micros. Thanks Scott
Forum: rodboard 12 years ago
scott stevens
Ok so I'm mentally challenged, if the rod flips how can I determine where the guides go?
Forum: rodboard 12 years ago
scott stevens
So, when I load the rod for guide placement I need to make sure the handle is secure so it wont spin?
Forum: rodboard 12 years ago
scott stevens
38. Re: load test
Thanks for the answers this site is outstanding for a beginner.
Forum: rodboard 12 years ago
scott stevens
39. load test
Hey guys newby question here. When loading a blank to find your guide spacing how are you supporting the rod and where?
Forum: rodboard 12 years ago
scott stevens
Thanks for the reply Tom. I have yet to build a rod but have been reading alot and ready to pull the trigger. All videos Ive seen the first step is spining the rod then I read on here that its not required, just a little confusing. Thanks Scott
Forum: rodboard |