SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 15 of 15
13 years ago
Jim Hitt
6. Re: Mandrels
Bob, I use a wood lathe. Thanks for all the reply's I will contact Backlash Tools.
Forum: rodboard 13 years ago
Jim Hitt
7. Mandrels
Looking for a couple 1/4" x 18" mandrels. Can some one point me in the right direction.
Thanks
Forum: rodboard 18 years ago
Jim Hitt
Tom,
Yes you are correct, it has an indent to hold a solid mandrel. Mark Crouse has one he uses on his lathe, but he doesn' remember where he got it.
Jim Hitt
Forum: rodboard 18 years ago
Jim Hitt
Hi all,
I am looking for a live center that screws directly onto the tail stock of the Taig micro lathe II. The one I am looking for is shaped like a half moon on the front where a mandrell would rest inside the half moon. I have searched for this part for hours with no luck. This is not an accessory offered by Taig. Would anyone know where I can buy one of these? Thank you for your help.
J
Forum: rodboard 18 years ago
Jim Hitt
10. Stripping Guides
Hi All,
I am getting ready to start a new project ( 9' 6wt ). What are the pros and cons on using three stripping guides vs two?
Thanks... Jim Hitt
Forum: rodboard 19 years ago
Jim Hitt
Bryan,
I like 1300 to 1500 RPM's - This is what works best for me.
Jim
Forum: rodboard 19 years ago
Jim Hitt
12. CC Data on RX7+?
Would anyone have CC data they would share on the new Rainshadow RX7+ in models 905-4 and 906-4 fly rods?
Thanks... Jim
Forum: rodboard 19 years ago
Jim Hitt
Glen,
Give Mike a call at J&M Grafix (304-269-2952) he does good work and will print any quanitity.
Jim
Forum: rodboard 19 years ago
Jim Hitt
If you enlarge the the AA chart will it still be accurate?
Thanks... Jim
Forum: rodboard
Current Page: 1 of 1
|