SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 12 of 12
11 years ago
louis caruso
Go To "R H Custom Rods" and contact Rich. He should have one for you....
Forum: rodboard 13 years ago
louis caruso
I have been making my own for a number of years. I find that id I wet the blank first, apply the decal and dab away any water from onder the decal I get good adheshion around the edges. I always wait 24 hrs to apply epoxy.
Forum: rodboard 14 years ago
louis caruso
I have been using it for about 4 months. The one issue I found is the first coat of epoxy cannot be thinned with acetone. The finish pulls away as if there is silicone on the wraps..
Forum: rodboard 15 years ago
louis caruso
What I do is put the cork tape on first before my reel seat. then I do the shrink tube extending over the ends. When you put on the reel seat you get a nice clean look and fit. I sometimes have to sand the cork tape slightly for a neat fit...
Forum: rodboard 15 years ago
louis caruso
I just upgraded with the 1/10 H P motor from Grainger. Best thing I did..... Makes a big differance shaping cork...
Forum: rodboard 16 years ago
louis caruso
Was so sorry I had to miss this one. Was to be my first and had to go out of town unexpectidly. Hope to see you all at the next one.....
Forum: rodboard 16 years ago
louis caruso
Thanks to all for the information....
Went to a few sites yesterday and got a headache with all the choices....LOL
Forum: rodboard 16 years ago
louis caruso
I'm looking for replacement O Rings for my clemens wrapper. Renzetti has them for $2.00 each which is high enough, but they have a weight listed as 2.00 pounds which comes to $13 + for shipping just 1.
Any help would be greatly appreciated
Forum: rodboard
Current Page: 1 of 1
|