SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 6 of 6
7 weeks ago
Mike Odddy
Charlie,
Thank you for the Link. I will be ordering one. I have a number of friends interested in the AT Tsuka 2 and the NFC XO handles.
Below is the YouTube video that showed this jig and other options.
Thank you.
Forum: rodboard 7 weeks ago
Mike Odddy
My Question and the quick reply from Kelsey @ NFC:
Question:
I recently purchased a, MB 724-1(X-Ray LMX) Black Mirror Finish (0889.86) and a XO Skeleton Handle.
Does trimming or cutting the blank to fit the handle void the warranty?
I need to remove 2.5" from the butt end to reduce the diameter from .593" to .574" to assemble with the XO handle.
(.574" was the
Forum: rodboard 7 weeks ago
Mike Odddy
Thank you for the continued responses.
I have contacted NFC via the Info email.
I will post the reply once rec'd.
p.s. I have read on the NFC site that some blanks may be cut down without changing the action. Unfortunately I do not recall where I read this. I will post if I come across it again.
Forum: rodboard 7 weeks ago
Mike Odddy
Thank you all for the responses. This will be my 1st time cutting a blank.
I would hate to damage a very nice blank.
This is all very helpful.
Forum: rodboard 7 weeks ago
Mike Odddy
Spencer,
Thank you for the advice and the safety tips. I will give it a try.
Forum: rodboard 7 weeks ago
Mike Odddy
What is the best way to cut an NFC X-Ray blank to fit an XO handle?
I need to remove roughly 2" from the butt end to get the blank to fit.
Will a Dremel with an abrasive Cut-off wheel work or are there other options I should consider?
Forum: rodboard
Current Page: 1 of 1
|