SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 3 of 3
3 years ago
Joshua Kennedy
Thanks, this is what I would have tried had I not already installed the stint, but very hard to remove that and start over now. I will check this before installing the stint from now on!
Forum: rodboard 3 years ago
Joshua Kennedy
I have already fastened a stint (glass blank) but my reel seat lock is just a fraction of an inch taller than the pocket is deep. If I epoxy the reel seat as-is I'm afraid the small gap will be unsightly and possibly let in some water. Is there any way to grind down the surface inside the grip without widening the inner diameter?
I have pictures to illustrate, but I can't figure out how to att
Forum: rodboard
Current Page: 1 of 1
|