SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 2 of 2
3 years ago
Jon McDermott
Thanks everyone for the advice, I appreciate it. I should have checked the FAQ, as Tom pointed out so kindly. Reaming it is, with care as suggested in this thread using a ream and slip technique and gloves.
Forum: rodboard 3 years ago
Jon McDermott
Folks -
When assembling EVA grips on a rod, do you ream the grips out first?
I have a rear grip with about a 0.25 inch (6.35 mm) diameter center hole. The diameter of the rod where the grip will go is about 13.5 mm. I know some folks say no need to ream, the EVA will stretch and slide down the rod with epoxy as the lubricant, but that much?
To put it another way, when I place the un-re
Forum: rodboard
Current Page: 1 of 1
|