SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 18 of 18
2 years ago
Anthony Pav
11. Custom grips
I am looking for someone who can make custom sized grips to the specs I would supply. I dont have a lathe to be able to turn my own and cant find any stock items that fit what I am looking for. These would be small one or two piece orders in eva and cork.
Thank you, Tony
Forum: rodboard 4 years ago
Anthony Pav
Thanks for the replies. I was originally going to use all KT's for the running train, based on the suggestions I have ordered some KB's.
Thank you, Tony
Forum: rodboard 4 years ago
Anthony Pav
I followed the guide layout as calculated on the Anglers Resource site. The recommendation was for four #5 guides after the choke guide, but they dont give distance measurements like they do for the reduction train. Four guides in the reduction train leaves what seems like excessive of distance between guides; hence my question on other peoples opinion/experience. I already have a fifth guide ava
Forum: rodboard 4 years ago
Anthony Pav
14. Running Train
I would be interested in hearing peoples opinions on the minimum/maximum distance between guides on the running train. I understand that a static test is needed to verify.
I am building a 7'4" med/hvy spinning rod that will be using 8lb flouro. and KT5's for the running train.
Thank you, Tony
Forum: rodboard 4 years ago
Anthony Pav
Mr Moslov,
I dont doubt there are situations where unavailability of raw materials makes completing customer orders impossible. I also understand that mistakes happen and defective product sometimes makes it to the customer. Its how those situations are handled and communicated between NFC and the customer which separates good customer service from bad/no customer service.
I dont think its
Forum: rodboard 4 years ago
Anthony Pav
Mr. Maslov,
I understand your point about long lead times should not be lumped in with customer service. But when a customer orders your product and reads "Please allow 2-3 weeks for shipment" on the order form then does not receive the order in that time frame and/or is unable to get a email or voice response when contacting NFC; then it most certainly becomes a customer service iss
Forum: rodboard 4 years ago
Anthony Pav
Just to clarify a few questions and comments;
The blank was not advertised as a "Blem" or "Second".
Retail price of the blank is $250.00, based on that I would put it in the premium category by a premium manufacturer. I did not pay the retail price, the manufacturer had ALL of their blanks on sale. So it was not a marked down blank because of the obvious defects.
Manu
Forum: rodboard 4 years ago
Anthony Pav
18. Blank Defects?
I recently purchased two blanks direct from a manufacturer. I did a quick inspection of both blanks when they arrived. One blank was perfect, but the other blank has a few areas that concern me. The blank has areas where a clear plastic film is trapped between the carbon wraps. It also has multiple areas where there are fibers (thread or carbon?) on the surface of the blank. The fibers appear to
Forum: rodboard
Current Page: 1 of 1
|