SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 10 of 10
7 years ago
Anthony Goulet
Jason Reddick Wrote:
-------------------------------------------------------
> I just did a microguide rod (American Tackle size
> 4's) and I used the guide tubing from Mudhole
> (4/64ths ID, catalog number = GT-0) - it worked
> perfectly, even on the skinny part of the rod at
> the tip. Just cut off narrow chunks with a razor
> blade, leaving enough room on the guide f
Forum: rodboard 7 years ago
Anthony Goulet
danny squier Wrote:
-------------------------------------------------------
> # model sf is item number at mudhole
So on the mudhole # SF wire guides, would that be a pac bay SF,or american tackle SF, in the black finish
Forum: rodboard 7 years ago
Anthony Goulet
Anthony Goulet Wrote:
-------------------------------------------------------
> Which black coated guides do you use if I may ask
So on the mudhole # SF wire guides, would that be a pac bay SF,or american tackle SF, in the black finish
Forum: rodboard 7 years ago
Anthony Goulet
those that have used the single wire fly guides that are coated black, will the black coating wear off
Forum: rodboard 7 years ago
Anthony Goulet
I want to make fiberglass rod for fishing perch in deep water. the only rod that comes close to what I have used would be a JM meatstick. So i am really really new at making good decisions. So I am asking for advice from those who have built rods and what components did you use for your build.
Forum: rodboard 7 years ago
Anthony Goulet
So I have been reading up on using fly guides on a fiberglass blank and since fly guides and regular guides are not the same size as far as ID. My question is that a fiberglass blank is going to be heavier than a carbon blank as well as less backbone then the carbon blank. Would I be better off with fly guides of a say a 4 or 5 size rather than a 6 or 8 also should I go with a low profile guide r
Forum: rodboard 7 years ago
Anthony Goulet
10. Ice rod blanks
Hello guys new to the site from Devils Lake ND the out of state walleye capital of the USA. My question is if you guys could give me some information on buying blanks for ice rods. I am looking to build my own custom rods from quality grade blanks like Thorne Brothers, TUCR, DH, ACE, Fenwick, or st. croix. Just to name a few thanks for any advice
Forum: rodboard
Current Page: 1 of 1
|