SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 5 of 5
4 years ago
Frank DAleo
Thank you to all who took the time to read and provide feedback!
Forum: rodboard 4 years ago
Frank DAleo
roger wilson Wrote:
-------------------------------------------------------
> Frank,
> You were able to move the guides. Fine.
> Do a final check on the alignment, coat the rod
> and go fishing.
>
> Whenever I wrap a rod, I tie the guides on tight
> enough so that I can just barely move them using
> both fingers of a strong hand. I have never had a
> blan
Forum: rodboard 4 years ago
Frank DAleo
Herb Ladenheim Wrote:
-------------------------------------------------------
> Gotcha Frank.
> BTW - what new thread tensioner are you using
> now?
> Herb
Hi Herb...purchased the CRB system a while ago with the HW-1 wrapper. The video states to keep the tension rod towards you...this is way too tight I think. it looks like they changed the design and dont even use the tensio
Forum: rodboard 4 years ago
Frank DAleo
Herb Ladenheim Wrote:
-------------------------------------------------------
> How did you initially try to move them into
> alignment? Perhaps the 2nd build is too loose???
> I assume that you needed the pick on the small
> guides - and the large guides could be used as
> levers to move them???
>
> I guess I'm concerned that you have no basis of
> comparison r
Forum: rodboard 4 years ago
Frank DAleo
Good Morning All,
I have been browsing this forum for a few years, reading, getting ideas and most importantly, learning from each of you!
The question I have is whether or not I should re wrap 8 guides because of being way too tight? Unfortunately, I did not check the play in the guides for alignment purposes, until I was ready to align! They were so tight, that I had to use a thread pic w
Forum: rodboard
Current Page: 1 of 1
|