Pro Wrap thread on Rainshadow 2pc. ultra-lite
Forum: rodboard

Couldn't figure out if this wrap was in Billy's book. But I figured out how to do it. Pro wrap thread on a Lamiglas inshore blank.
Forum: rodboard

Forum: rodboard

Fugi ACS painted flat Desert Storm Tan, crushed mud acrylic turned by JP Timberlake
Forum: rodboard

Batson Magnum Taper Blank, Fugi ACS Reel Seat, Acrylic Grip & Butt by JP Timberlake.
Forum: rodboard

Rainshadow RX7, cork work by JP Timberlake
Forum: rodboard

8'6" metal fly rod blank my dad wanted refurbished. Painted OD green, Gudebrod size A thread in rust, almond and sandstone. This rod is heavy!
Forum: rodboard

Forum: rodboard

Forum: rodboard

Forum: rodboard

Forum: rodboard

6' light action pearl white blank.
Forum: rodboard

5' UL 2 Piece Blank
Forum: rodboard

Forum: rodboard

Fllet & Release
Forum: rodboard

How is the eva prepped?
Forum: rodboard

The main colors on my tiger wrap are brown, od green and dark yellow. Can I use a color from the main wrap for my single second overwrap or should the color be of great contrast? Thanks, Tim
Forum: rodboard

Is it really necessary to wait the recommended overnight before applying the thread epoxy? Thanks
Forum: rodboard

Those are two-three hours away.
Forum: rodboard

Where would I measure the blank in relation to where the hypalon grip will sit to get the grip's ID? Thanks
Forum: rodboard

Just received some guides from them a couple of days ago. So they are still in business.
Forum: rodboard

I understand it calculates the length but the vw length is not gonna be where I measured the diameter of the blank.
Forum: rodboard

I input the butt & tip diameters and then the amount of spaces but I never get the same length as my measured length. How is my wrap supposed to close if I can't get the same length from VIZ-Wrap?
Forum: rodboard

I can log into the forum just fine but to enlarge photos they want me to log in again but I get an Invalid password? Thanks
Forum: rodboard

Not quite sure I fully understand your question but if your epoxy is creeping up onto your cork; this what I do. When applying the epoxy stay away from the cork or winding checks at first. after you have epoxied the middle of your wrap use a smaller size brush to work the epoxy up to the edges. Turn the rod by hand and not with a dryer.
Forum: rodboard

Thanks, Billy
Forum: rodboard

At the ends of my crosswrap working towards the center the of the wrap, for about three crossovers the madiera thread loosens and becomes puffy. Am I using too much tension? Thanks
Forum: rodboard

Up/down is longitudinal and left/right is lateral.
Forum: rodboard

Would size A thread be strong enough for guide wraps on say a 30 lb boat rod?
Forum: rodboard

Just had the same prblem. Did what Tom said and works fine.
Forum: rodboard