SPONSORS
2024 ICRBE EXPO |
Trim rings
Posted by:
John Chaney
(---.dsl.kscymo.swbell.net)
Date: January 31, 2002 09:27AM
Can I glue nylon trim rings between my cork rings? Will it hold? Thanks, John Re: Trim rings
Posted by:
Gordon Glover
(---.sttl.uswest.net)
Date: January 31, 2002 08:52PM
Yes you can,I have done a few.I use eather a 2 part epoxy or if your only putting in a couple I've had good luck with contact cement.You might check your local library and see if they have a copy of Dale Clemens Video on( Building your own Rod or Creative Rod Crafting) They Have been alot of help over the years. Good Luck and Tight Lines Gordon Glover Customrodart@netscape.net Re: Trim rings
Posted by:
Bill Doherty
(---.rdu.bellsouth.net)
Date: January 31, 2002 10:12PM
John, If you want to see a photo of this, go to my site. When you are on my main page, click on the page for "grips", and scroll to the bottom of that page. The photo is of a cigar grip on a 4wt fly rod. www.dohertycustomrods.com Bill Doherty Re: Trim rings
Posted by:
Steve Parks
(---.mobile1.al.home.com)
Date: February 01, 2002 08:45AM
Nylon rings should not be a problem. You could also use the foam sheets from Wal~Mart in the crafts department. I made my first grip using the foam and it turned out nice.....to me anyway. Go here and see [momentoffame.com]. Steve Sorry, only registered users may post in this forum.
|