SPONSORS
2024 ICRBE EXPO |
verticle spine finder
Posted by:
jnail
(---.unitelc.com)
Date: December 23, 2001 07:43PM
are there any of you out there who are machinists who would like to make up just the cone+bearing to be used in the equal angle spacing set up? Re: verticle spine finder
Posted by:
Andy
(---.bctel.ca)
Date: December 23, 2001 11:37PM
You can get one from Dick French. I use the tail stock live center from the Clemens lathe. This has a double bearing on a short shaft with a 60 degree cone. All you need to do is build a base to house the shaft. Andy Re: verticle spine finder
Posted by:
Capt Neil Faulkner
(---.proxy.aol.com)
Date: December 24, 2001 08:29AM
Hi. Clemens sells the Vertical Spine Finder. Click on Clemens Tackle. Capt Neil Sorry, only registered users may post in this forum.
|