Good afternoon all,

As the subject says, I am looking for a 7’6” version of the MB708. I am thinking I could get very close by cutting down an MB808 to 90”. I tried the delta 767 and it’s far more powerful than what I am looking for. I have a delta version of the MB708 and it seems to be right on track for what I am after except for the length.

Thanks
Tom

What about cutting the 7108or 7109 down to 7'6?

Building rods in MA, Building the community around the world



Edited 1 time(s). Last edit at 04/06/2023 01:19PM by El Bolinger.

You might want to go the other direction and extend the MB708. Action will be a tad faster that way, whereas cutting down the 808 will result in a bit slower action regardless if you cut it from the tip or the butt.

..........

I am building 7108 cut to 7'5" is sweet! It is still quite fast at this length.

@ROB you have any CCS data for that?

Building rods in MA, Building the community around the world

I appreciate the suggestions gentlemen, I am gonna order both blanks and give it a shot each way.

Thanks
Tom

No sir. Just a rookie.