Question on using the sticker provided for this blank.... Since this blank has the ribbed texture, ( for lack of better terms ), i cannot get the factory provided sticker to adhere properly.. anybody else having this issue or what am i doing wrong ?? Thanks in advance... G

Hello Greg.

Lay down a layer of epoxy where the sticker is going to go and once it's at least tacky dry put on your sticker.

If you are unsure you can get it down on a tacky surface without leaving prints just wait till it's dry, the second coat over the sticker will still adhere fine.


Tight Wraps & Tighter Lines.

Bob,

New Bern, NC.

Thanks... thought that may have been the solution but i had already screwed it up.. should have asked sooner or taken a step back to THINK! I have another to do so will do that... thanks... G

If you need another decal, contact NFC. They should send you another.
Norm

You could try just wiping the area with acetone - clean cloth, coz it might have a wax surface of some sort

It's most likely simply the ridges. As Robert A says, put the new label on a layer of epoxy, then another layer on top.