SPONSORS
![]()
2023 EXPO |
Offset Turning - Hammer handle-like grip
Posted by:
Ladd Flock
(---)
Date: January 23, 2023 04:53PM
Any ideas for how to drill out a hammer style handle to use as a grip. I'm thinking about lathing some offset hammer-handle grips for small stream fly rods. Can't envision how to drill them out once they are turned.
[www.youtube.com] Thanks for any insight. Re: Offset Turning - Hammer handle-like grip
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: January 23, 2023 05:35PM
Hello Ladd.
Vol/Issue........Article................Page........ 11/6 Wood Inserts & Grips Center Boring. 22 Hope this helps. Tight Wraps & Tighter Lines. Bob, New Bern, NC. Re: Offset Turning - Hammer handle-like grip
Posted by:
Tom Kirkman
(Moderator)
Date: January 23, 2023 09:21PM
We did a hammer handle turning article in RodMaker but I'm not sure that's it. I'd have to go back and look.
.......... Sorry, only registered users may post in this forum.
|