SPONSORS
2024 ICRBE EXPO |
NFC rod diameters
Posted by:
Glenn Tucker
(---)
Date: December 25, 2022 03:02PM
Hey all, hope you are all having a great holiday. I am trying to order a few exposed blank reel seats as I have a few blanks coming and the rods need to be completed by the first week in Feb. Although I realize that there are going to be slight differences, even between blanks of the same model and batch, I was hoping some folks on here may have the same blanks and could possibly throw a caliper on them for me. It will at least get me close and I will just order a couple slightly smaller and larger...they will get used eventually. If anyone has a flip 769-1 SM, SJ 705-1 SM and a MB 709-1 SM. If you only have 1 or 2 of them that would help too. If multiple people respond it would give me an idea of the consistency of the diameters. I would like the measurement taken at 12" up from the butt. I would really appreciate any help you can provide. Take care. Re: NFC rod diameters
Posted by:
Ken Delbridge
(192.55.54.---)
Date: December 27, 2022 02:47PM
Based on building with several blank brands I strongly recommend ordering & receiving the blanks and then taking the seat ID measurements based on the handle lengths you plan on building to, unless you know with certainty that you will need to arbor the seat regardless (i.e. fly blanks, many salt water build outs). I have seen some blank variability on repeat builds with equivalent blank models, where different seat sizes were needed to fit the handle plan I was building to. Re: NFC rod diameters
Posted by:
Glenn Tucker
(---)
Date: December 27, 2022 04:48PM
Thanks for the advice. I just notification that the blanks shipped today so I will wait until I get the. Sorry, only registered users may post in this forum.
|