SPONSORS
2024 ICRBE EXPO |
Integrated Carbon Fiber Spinning Handle
Posted by:
Bill Falconer
(207.203.39.---)
Date: April 26, 2013 02:13PM Another Integrated Carbon Fiber spinning handle inspired by Capt. Mike Pedersen. I am following Mike's lead but I trim the threaded barrel off the seat and do not make an arbor out of the foam core. Rather, I glue a separate arbor in the threaded section. Once the handle is finished and mounted I then ream to fit and glue the threaded barrel up against the seat. Foregrip optional. You can see a very little bit of holo glitter in this grip. Hard to capture with a photo, but the multiple very thin layers of epoxy give this tremendous depth and luster...especially in sunlight. Sorry, only registered users may post in this forum.
|