SPONSORS
2024 ICRBE EXPO |
Cork Inlay Jigs
Posted by:
Jim Gargiule
(---)
Date: October 20, 2020 04:59PM
Does anyone know of inlay jigs that will accept 1.5” rings? I have the ones from Mudhole and don’t have a lot of use for 1.25” stuff. I just got a quote from a machine shop to make some and the cost is way too much. Re: Cork Inlay Jigs
Posted by:
Bill Sidney
(---.gci.net)
Date: October 21, 2020 05:10PM
If you want one you will have to go to a machine shop , an bring what you have an see if they can make what you want ,
you might need to go to a large shop , because of what they will need to do the job , all shops don't have what they need to do what you want , William Sidney AK Re: Cork Inlay Jigs
Posted by:
Bill Sidney
(---.gci.net)
Date: October 21, 2020 05:10PM
If you want one you will have to go to a machine shop , an bring what you have an see if they can make what you want ,
you might need to go to a large shop , because of what they will need to do the job , all shops don't have what they need to do what you want , William Sidney AK Re: Cork Inlay Jigs
Posted by:
Jim Gargiule
(---)
Date: October 23, 2020 12:07AM
Yes thank you. I took them to one shop and was quoted $700 for the set. I’d consider it if I was still building professionally but I only wrap for friends, family, or myself anymore. So I’m not going that route. Re: Cork Inlay Jigs
Posted by:
Bill Sidney
(---.gci.net)
Date: October 23, 2020 12:55PM
I under stand , Labor an equipment are not cheep now , William Sidney AK Sorry, only registered users may post in this forum.
|