SPONSORS
2024 ICRBE EXPO |
Heat shrink as decorative wrap.
Posted by:
Scott Lawrence
(118.208.29.---)
Date: September 19, 2019 05:45AM
Hi guys, has anyone tried some of the cross shrink wrap as a decorative area. Like a 4 to 6 inch area in front of foregrip with a couple of trim bands at each end and then a couple of coats of epoxy.
Tight lines Scott Re: Heat shrink as decorative wrap.
Posted by:
Mark Talmo
(71.147.59.---)
Date: September 19, 2019 03:45PM
No, but there is no reason you couldn’t. Imagination should be endless and beauty is in the eye of the beholder. Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: Heat shrink as decorative wrap.
Posted by:
Scott Lawrence
(118.208.6.---)
Date: September 20, 2019 04:50AM
Might get a bit and experiment on some scrap blank.
Scott Sorry, only registered users may post in this forum.
|