SPONSORS
2024 ICRBE EXPO |
Attempting Composite Grips
Posted by:
Mark D Schulte
(---.sub-174-221-25.myvzw.com)
Date: January 17, 2019 02:48PM
I am going to attempt to make my own composite handles. What would be the best epoxies to work with. I am going to use colored carbon/fg sleeves. Also, where would the best supplier for the foam tubes be? Thanks in advance Re: Attempting Composite Grips
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: January 17, 2019 10:31PM
Soller Composites is a good starting point. Tubes don't know, the ones at Mudhole are spendy, much cheaper to make my own. Re: Attempting Composite Grips
Posted by:
Mark Talmo
(71.147.59.---)
Date: January 18, 2019 02:31PM
10X Soller Composits Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: Attempting Composite Grips
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: January 18, 2019 04:52PM
Foam cores for carbon sleeve grips are available from Batson dealers on the left. Sorry, only registered users may post in this forum.
|