SPONSORS
2024 ICRBE EXPO |
OK to Sand Rod Tip?
Posted by:
David Thorpe
(---.accessllc.net)
Date: April 15, 2003 03:17PM
The tip-top will fit down only about 1/3 of the way. Is it OK to sand just enough off the rod tip to get a snug fit? The blank is a Rainshadow RX-7 casting rod. Re: OK to Sand Rod Tip?
Posted by:
Tom Kirkman
(---.WLDF.splitrock.net)
Date: April 15, 2003 03:42PM
No, don't do it. You can scrape off any finish, but do not sand into the tip at all or run the very real risk of failure at that point. You just don't have enough material to play with there. Get the correct sized top. ........ Sorry, only registered users may post in this forum.
|