SPONSORS
2024 ICRBE EXPO |
Finish on a paracord handle-do I need to use CP?
Posted by:
Paul Wood
(---.columbus.res.rr.com)
Date: November 22, 2017 09:08PM
I searched the forum concerning cord handles-specifically paracord handles, and have decided to finish the handles using Perma-Gloss. I've never used that before, and while I intend to test finish on a scrap blank, I was wondering if I need to apply CP to the cord before the finish? I'm not worried about how the finish will affect the color, just how it will adhere to the cord.
As always, thanks in advance for any advice! Re: Finish on a paracord handle-do I need to use CP?
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: November 22, 2017 10:17PM
As long as there is no contaminants like silicone on the cord, you'll have no problems. Re: Finish on a paracord handle-do I need to use CP?
Posted by:
Matthew Pitrowski
(---.lightspeed.milwwi.sbcglobal.net)
Date: November 22, 2017 11:05PM
perma gloss is xylene based and does a excellent job but it might eat some materials my preferred one step or no mix finish has become the rod dancer thread master as it is water based urethane and is as tough as the blank finish doesn't yellow over time remains clear uv protected and doesn't change the thread color you would have to apply several coats but no cp is needed The best day to be alive is always tomorrow !! Think out side the box when all else fails !!! Wi. Re: Finish on a paracord handle-do I need to use CP?
Posted by:
Nick Lam
(172.56.38.---)
Date: November 24, 2017 01:13AM
I prefer no coating at all. Finish and gloss flake and scratch off in pieces when covering a relatively soft material such as cord. The sign of use on tightly wrapped cord wears nicely. Also, I prefer Atwood cord and tarred seine twine over paracord, but to each their own though.
Nick Re: Finish on a paracord handle-do I need to use CP?
Posted by:
darrel odland
(---.lightspeed.frokca.sbcglobal.net)
Date: November 26, 2017 07:08PM
Paul, I have done a few cord wraps recently, My opinion is this, I use flexcoat thread sealer generously on the cord. This helps bond the cord to rod in addition to the type glue you use. (I use two ton epoxy) Then to finish I use a Clear wood lacquer from a spray can bought at my local Ace Hardware. I agree with Nick as I to, think that the Atwood cord is much better, It is stiffer and has 2 more base cords making it less prone to flattening out when in use. Color selection is limited though. Let us know how your wraps turn out
"bent rods to ya" Darrel. Sorry, only registered users may post in this forum.
|