SPONSORS
2024 ICRBE EXPO |
Pistol Grip Holder
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: August 10, 2016 12:49PM
Steve can you please send me your contact info, as I need to get ahold of you Ron Weber Re: Pistol Grip Holder
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: August 10, 2016 06:39PM
Gentleman has contacted me and is being taken care of Ron Weber Re: Pistol Grip Holder
Posted by:
Dennis Danku
(---.dyn.optonline.net)
Date: August 14, 2016 11:38PM
Using a small whisk broom , chuck the handle in your lathe, divide the bristles around the pistol grip so that the blank is centered with the chuck, then wrap the bristles tight around the grip with a cord or anything that will hold it all together. Dennis J. Danku (Sayreville,NJ) Re: Pistol Grip Holder
Posted by:
Dennis Danku
(---.dyn.optonline.net)
Date: August 14, 2016 11:40PM
Using a small whisk broom , chuck the handle in your lathe, divide the bristles around the pistol grip so that the blank is centered with the chuck, then wrap the bristles tight around the grip with a cord or anything that will hold it all together. Dennis J. Danku (Sayreville,NJ) Sorry, only registered users may post in this forum.
|