SPONSORS
2024 ICRBE EXPO |
how to bore MHXSGFBE
Posted by:
Thomas Kaufmann
(---.direcpc.com)
Date: July 18, 2015 06:56PM
Ok gents,
I normally use butt grips that I can use my dream reamers or some other type of reamer on, however the gentleman that I am building for would like to use the matching butt grip to the one behind the real seat. What do you all suggest for this type of rear grip? It is their MHX Winn grip is you were not sure which one it is. Thanks, Tom Re: how to bore MHXSGFBE
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 18, 2015 09:00PM
Thomas,
Can you upload a picture of the reel seat and anything else that you are trying to match. If I fit a grip to a rod that has a butt cap on the end and I don't want to cut a hole in the butt cap, I use a simple longer drill bit to drill out the size of the grip to the size that will fit the extreme butt of the blank. Then, I just use spaced out masking tape to take care of any taper that might be on the blank - for a nice fitting grip. Be safe Re: how to bore MHXSGFBE
Posted by:
Thomas Kaufmann
(---.direcpc.com)
Date: July 18, 2015 10:23PM
Roger,
I took a chance and used a fostner bit and it worked perfectly. I figured I had two of the grips so if I screwed up one it was not a big deal. Thanks, Tom Sorry, only registered users may post in this forum.
|