SPONSORS
2025 ICRBE |
Fuji ECSM reel seat question
Posted by:
Joe Coughlin
(---.mpls.qwest.net)
Date: March 03, 2015 10:08PM
What is the ID of a Fuji ECSM real seat at the rear edge where it mates with the rear grip? What is the OD at that same location? I'm looking for a grip to that will work.
Joe Re: Fuji ECSM reel seat question
Posted by:
Bill Falconer
(207.203.39.---)
Date: March 04, 2015 08:54AM
Hello Joe -
I'm out of the shop and can't measure for you but Angler's Research / Fuji (sponsor at left) probably has the dimensions on their website. Also there are some sponsors at left who sell split grips in cork or EVA to fit the ECSM - Swampland, Rod Room, and Mudhole have them for sure. Others probably do as well. In my experience you can call any of the sponsors and tell them what you are trying to do and they'll help you get a grip, tip top, etc. to fit your project perfectly. You can always make your own carbon fiber grip to fit - they work really well with the ECSM. Or anything else IMHO. Hope this helps. Good luck! Bill Re: Fuji ECSM reel seat question
Posted by:
David Parsons
(---.hsd1.pa.comcast.net)
Date: March 05, 2015 08:26PM
Joe id at rear 0.900 od is1.050 to 1.070 Sorry, only registered users may post in this forum.
|